List of Reinforcement types, stress check and temperature points
There are three possible reinforcement arrangements available:
- POINT –An individual reinforcement point is defined with type REIPSI only.
- POLYGON – A polygonal reinforcement line is defined with a start point (REIPOB), a middle point (REIPOM) and an end point (REIPOE).
- CURVE – A curved reinforcement line defining a complete circle is defined with the center point of the circle (REICUM) of reinforcement only.
Note: It is possible to combine all the reinforcement types for defining any arrangement of the reinforcement in the selected cross-section.
| Setting | Description |
|---|---|
| STRESS CHECK POINT | There is possible to set the points in the cross section (FIBPOI) for which the stresses later will be calculated. |
| TEMPERATURE POINT | There is possible to set the points in the cross section (TMPPOI) for which the temperature gradient will be set |
| SHEAR CAPACITY PERIMETER POINTS | For 'Shear capacity check' there is necessary to define a perimeter in the cross section. There are two possible polygonal point types available: Points, connected with lines (PERPOI) or points, connected with curves (PERCRC), resp. a combination of both point types. |
| SHEAR CAPACITY CROSS LINE | For 'Shear capacity check' there is necessary to define a cross-line, which crosses the cross-section. The line has to be defined by two points: begin point (LINPOB) and end point (LINPOE) pad2710 |